Bob Moore brings you Bob TV. RC Turbine Jet Building Action!

Episode #171 Pt.6 | Laying up Real Stab

 

Tagged as:

2 Responses to “Episode #171 Pt.6 | Laying up Real Stab”

  1. Jim Jamieson says:

    It was mentioned earlier about the need for adding counter balance lead to both elevators to help unload the servo(s). I am assuming you’re going to use two servos, one on each side right? There’s going to be a lot of pressure for the servo(s) to deal with if those large elevons are not counterbalanced. I suppose the best time to figure this out though is when it comes time to check the CG, because tail heavy is worse than nose heavy.

    JJ

  2. Todd says:

    Was wondering if you did or needed to cap the end of the tube just incase some glue might find it way in there and make it tuff to get them fitted later..Thanks Todd

Leave a Reply

You can use these tags: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>